Partial Die Cutting: Punny Pals

Hello Crafty Friends & welcome back to DanYell Scraps.

 Punny Pals is one of my all time favorite stamp and die sets. (Heads up the coordinating punny pals thincut die set is on the going soon list, so if you have had your eye on it, now is the time to get it.) I have for you a super simple yet complicated looking card. It's really not that complicated....trust me.

So lets go over just how this must have card is made!
Here are the supplies you'll need to duplicate the above card:

  • White Daisy Cardstock
  • Punny Pals Thincut Die Set
  • Coordinating Punny Pals Stamp Set
  • Shinhan Markers in G46, BR116, R11, BR96, WG4, & Colorless Blender
  • Black momento Ink
  • Clear Shimmer Brush
  • Cricut Cuttlebug™ - if you don't have one - Click here to learn how you can get one through ME your favorite CTMH Gal! 
Here are the step by step instructions:
  1. Start with White Daisy cardstock cut to 4.25 x 5.00 inch
  2. Line the Punny Pal Thincut dies at the top of your base, as close to the edge with out going over. make notations on either side of the dies that you want NOT cut. Remove the Thincuts and complete the line.
  3. Secure the Punny Pal Thincut dies with a low tac tape such as washi tape. 
  4. assemble your cutting plates and material as you normally would, with the exception of the top plate. 
  5. The top plate will be placed partially over the materials and Thincuts, using this line you drew earlier as a guide. The edge of your plate should marry up to this line. Whatever the top plate covers will be cut. the area the top plate does NOT cover will NOT be cut. 
  6. Remove the material, and using a craft knife or trimmer, cut away the white daisy in between each Thincut.
  7. I colored the "ground" in WG4, then used the colorless blender to remove color starting with a heavy hand at the bottom and gradually working up. Any color would work for this. 
  8. Color the Punny Pal character's as you see fit.
  9. Stamp your desired sentiment, Thank you, seen on this card is from the 2018 Feb Stamp of the Month Sunny thoughts. 
  10. Line your card panel where the punny pals blend into the card with the top of your card base. Mark at the bottom where your card base hangs off, and then trim there. This keeps your card at a 4.25 x 5.00 inch A2 size. 
  11. Adhere your Panel to the Card base with your favorite strong adhesive. 
  12. Apply Shimmer to any areas, this card has the shimmer applied to the sentiment and the banana in the monkey's hand. 

Thank you for stopping by today.

You can find all the supplies used today in my online shop: www.DanYellscraps.ctmh.com 
** Disclaimer ** I do receive a small commission when purchases are made via this link. 

Happy Crafting. 

No comments:

Post a Comment